Table of Contents
Advertisement
8
9
10
11
12
13
14
15
16
17
18
3HAC022033-001 Revision: M
Action
Use the rotation tool in order to rotate the
motor pinion when mating it to the gear!
Fit the motor, making sure the motor pinion
is properly mated to the gear, axis 4.
Remove the guide pins.
Secure the motor with four attachment
screws and plain washers.
If required, use the extension 300mm for
bits 1/2".
Disconnect the brake release voltage.
Reconnect all connectors beneath the motor
cover.
Refit the cover on top of the motor with its
four attachment screws.
Refit the cable gland cover at the cable exit
with its two attachment screws.
Perform a leak-down test if the gearbox has
been drained.
Refill the gearbox with oil if drained.
Recalibrate the robot!
DANGER
Make sure all safety requirements are met
when performing the first test run. These
are further detailed in the section
- First test run may cause injury or damage!
on page
49.
© Copyright 2007-2013 ABB. All rights reserved.
4.6.4 Replacement of motor, axis 4
Note
Art. no. is specified in
ment on page
333.
Make sure the motor pinion does not get
damaged!
Make sure the motor is turned the right
direction, that is the cables facing for-
wards.
xx0200000165
The rotation tool is used beneath the mo-
tor cover, directly on the motor shaft as
shown in figure above.
•
A: Rotation tool.
4 pcs: M10 x 80, tightening torque: 50 Nm.
Art. no. is specified in
ment on page
333.
Make sure the cover is tightly sealed!
Shown in the figure
page
333.
Detailed in the section
down test on page
Detailed in the section
axis 4 on page
Calibration is detailed in a separate calib-
ration manual enclosed with the calibra-
tion tools.
General calibration information is included
in section
Calibration information on
page
387.
DANGER
4 Repair
Continued
Required equip-
Required equip-
Location of motor on
Performing a leak-
236.
Filling, oil, gearbox
207.
337
Advertisement
Table of Contents
