Table of Contents
Advertisement
4 Repair
4.4.1 Replacing turning disk
4.4 Upper and lower arm
4.4.1 Replacing turning disk
Location of turning disk
The turning disk is located in the center of the wrist unit as shown in the figure
below.
xx0100000129
A
B
C
Required equipment
Equipment, etc.
Turning disk, dia. 250
Turning disk, insulated
O-ring
Grease
Standard toolkit
Continues on next page
258
Turning disk
Oil plug, filling (oil plug for draining is located on the opposite side of the tilt-
house)
Turning disk attachment screws, 33 pcs
Spare part no.
3HAC13193-1
3HAC023124-002
© Copyright 2007-2013 ABB. All rights reserved.
Art. no.
Note
Does not include o-ring!
21522012-433
Must be replaced when repla-
cing the turning disk!
3HAB3537-1
Used to lubricate the o-ring.
-
Content is defined in section
Standard tools on page
3HAC022033-001 Revision: M
411.
Advertisement
Table of Contents
