Table of Contents
Advertisement
3 Maintenance
3.5.2 Lubrication of spherical roller bearing, balancing device
Continued
Lubrication, balancing device bearing
The procedure below details how to lubricate the spherical roller bearing.
1
2
3
224
Action
DANGER
Turn off all:
•
electric power supply to the robot
•
hydraulic pressure supply to the robot
•
air pressure supply to the robot
Before entering the robot working area.
Lubricate the spherical roller bearing through
the lubrication nipple in the ear with grease.
Fill until excessive grease is forced out
between the shaft and the sealing spacer.
Clean the area from any excessive grease
and check the area once again after operation
of the robot, in order to make sure there is
no incorrect leakage from the o-rings.
© Copyright 2007-2013 ABB. All rights reserved.
Note
Art. no. and amount is specified in
quired equipment on page
Shown in the figure
Location of bearing
on page
223!
The balancing device must be mounted
on the robot when lubricating the
bearing!
Read more about the inspection in
section Inspection, balancing device -
Check for leakage on page
3HAC022033-001 Revision: M
Re-
223!
172.
Advertisement
Table of Contents
