Table of Contents
Advertisement
3 Maintenance
3.3.2 Inspection, oil level gearbox axis 2
Continued
Oil plug, later design
The axis 2 gearbox is located in the lower arm rotational center. The figure below
shows the later design of the gearbox cover, where the oil plug for filling is located
33 mm below the original placement.
xx0200000112
A
B
C
D
Required equipment
Equipment etc.
Lubricating oil
Standard toolkit
Other tools and procedures may
be required. See references to
these procedures in the step-by-
step instructions below.
Continues on next page
156
Gearbox, axis 2 (behind motor attachment not shown in figure )
Oil plug, filling (later design)
Oil plug, draining
Label, specifies the type of oil in axis 2 gearbox
Art. no.
See
of oil in gearboxes on
page
-
© Copyright 2007-2013 ABB. All rights reserved.
Note
Type and amount
194.
Content is defined in section
Standard tools on page
These procedures include refer-
ences to the tools required.
3HAC022033-001 Revision: M
411.
Advertisement
Table of Contents
