ABB IRB 7600 - 500/2.55 Product Manual page 312

4 Repair
4.5.5 Unloading the balancing device using hydraulic press tool
Continued
C
D
E
F
G
Required equipment
Equipment, etc.
Press tool, balancing device
Hydraulic cylinder
Hydraulic pump, 80 MPa
Standard toolkit
Using the correct press device
The different designs of the balancing device require different versions of the press
device, included in the complete press tool. The table below specifies which press
device to use to which balancing device.
The article number of the balancing device may be found on a label at the rear of
the balancing device.
Balancing device
Art. no: 3HAC14675-2
xx0300000605
Art. no: 3HAC023018-001
xx0700000423
Continues on next page
312
Press device
Bolt, press device
Moving pin with marking
Bolt (4 pcs)
Pin, attached to the fix plate
Art. no.
3HAC020902-001
3HAC11731-1
3HAC13086-1
-
© Copyright 2007-2013 ABB. All rights reserved.
Note
Includes
• press device 3HAC15767-2
• press device 3HAC18100-1
Choose the correct device, depending
on model of balancing device.
To be used with the press tool.
To be used with the hydraulic cylinder.
Content is defined in section
tools on page 411.
Press device
Art. no: 3HAC15767-2 (for balancing
device 3HAC14675-1)
xx0300000600
Art. no: 3HAC18100-1 (for balancing
device 3HAC023018-001)
xx0300000599
3HAC022033-001 Revision: M
Standard