Delta C2000 Series User Manual page 99

Chapter 7 Optional Accessories
Descriptions of Keypad Functions
Start Operation Key
1.
2.
3.
Stop Command Key. This key has the highest processing priority in any situation.
1.
2.
3.
Operation Direction Key
1.
2.
ENTER Key
Press ENTER and go to the next level. If it is the last level then press ENTER to execute the
command.
ESC Key
ESC key function is to leave current menu and return to the last menu. It is also functioned as
a return key or cancel key in the sub-menu.
Press menu to return to main menu.
Menu content:
KPC-CE01 does not support function 5 ~13.
1. Parameter setup
2. Copy Parameter
3. Keypad Locked
4. PLC Function
5. Copy PLC
6. Fault Record
A
: LED Disp lay
D ispla y freq uen cy, cu rre nt, vo ltag e and erro r etc.
: Status Indi cator
F: Fre que ncy C omma nd
H: Outp ut Frequ ency
U: User De fine d Uni ts
ERR: CAN Erro r Ind icator
RU N: CAN Ru n Indi ca tor
C
: Function
(Re fer to the chart foll ow s for deta il de scripti on )
It is only valid when the source of operation command is from the keypad.
It can operate the AC motor drive by the function setting and the RUN LED will be ON.
It can be pressed again and again at stop process.
When it receives STOP command, no matter the AC motor drive is in operation or stop
status, the AC motor drive needs to execute "STOP" command.
The RESET key can be used to reset the drive after the fault occurs.
The reasons why the error cannot be reset:
a. Because the condition which triggers the fault is not cleared. When the condition is
cleared, the fault can be reset
b. Because it's the fault status checking when power-on. When the condition is cleared,
repower again, and the fault can be reset
This key is only control the operation direction NOT for activate the drive. FWD:
forward, REV: reverse.
Refer to the LED descriptions for more details.
7. Quick start
8. Display Setup
9. Time Setup
10. Language Setup
11. Startup Menu
12. Main Page
13. PC Link
7-18