Delta C2000 Series User Manual page 430

Bit 7=0: frequency is saved before power turns off. When power turns on again, the display
frequency will be the memorized frequency.
Bit 7=1: frequency is not saved before power turns off. When power turns ON again, the display
frequency will be 0.00Hz.
Bit 8=0: maximum speed for point-to-point position control is control by the setting of Pr.11-43.
Bit 8=1: maximum speed for point-to-point position control is control by the multi-step speed
setting of the external terminal device. When multi-step speed of the external device is set to 0,
the maximum operation speed will bet the setting of Pr.11-43.
Per Unit of System Inertia
1~65535 256=1PU
Settings
To get the system inertia from Pr.11-01, user needs to set Pr.11-00 to bit1=1 and execute
continuous forward/reverse running.
Unit of induction motor system inertia is 0.001kg-m^2:
Power Setting
1HP
2HP
3HP
5HP
7.5HP
10HP
15HP
The base value for induction motor system inertia is set by Pr.05-38 and the unit is in 0.001kg-m^2.
ASR1/ASR2 Switch Frequency
Settings 5.00~599.00Hz
ASR1 Low-speed Bandwidth
Settings 1~40Hz (IM)/ 1~100Hz (PM)
Chapter 12 Description of Parameter Settings
Power
2.3 20HP
4.3 25HP
8.3 30HP
14.8 40HP
26.0 50HP
35.8 60HP
74.3 75HP
Setting
95.3
142.8
176.5
202.5
355.5
410.8
494.8
12.1-11-2
Factory Setting: 256
Power Setting
100HP 1056.5
125HP 1275.3
150HP 1900.0
175HP 2150.0
215HP 2800.0
300HP 3550.0
Factory Setting: 7.00
Factory Setting: 10