Delta C2000 Series User Manual page 194

5. Copy PLC
Chapter 10 Digital Keypad
4 duplicates are provided
The steps are shown in the example below.
Example: Saved in the motor drive.
1 Go to Copy PLC
2 Select a parameter group to copy then press
ENTER
1 Select 1: Save in the motor drive.
2. Press ENTER key to go to "Save in the motor
Begin to copy PLC until it is done.
Once copying PLC is done, keypad will automatically
be back to this screen.
If "Option 1: Save in the motor drive" is selected,
verify if the PLC program is built-in to KPC-CC01
keypad.
keypad while "Option 1: Save in the motor drive" is
selected, an "ERR8 Warning: Type not matching" will
be display on the screen.
Unplug and plug back the keypad while copying the
PLC program will have a CPLt warning.
Example: Saved in the keypad.
1. Once copying PLC is done, keypad will
automatically be back to this screen.
2. Select the parameter group which needs to be
copied and press ENTER key.
Press ENTER key to go to "Save in the motor drive"
screen.
If WPLSoft editor is installed and password is set,
enter the password to save the file onto digital
display.
Use Up/Down key to select a symbol.
Use Left/Right key to move the cursor to select a file
name.
String & Symbol Table:
10-9
drive" screen.
If PLC program is not available in the