Delta C2000 Series User Manual page 333

Chapter 12 Description of Parameter Settings
Analog Frequency Command for Reverse Run
Settings
Parameter 03-10 is used to enable reverse run command when a negative frequency (negative
bias and gain) is input to AVI or ACI analog signal input (except AUI).
Condition for negative frequency (reverse)
1. Pr03-10=1
2. Bias mode=Serve bias as center
3 Corresponded analog input gain < 0(negative), make input frequency be negative.
In using addition function of analog input (Pr03-18=1), when analog signal is negative after
adding, this parameter can be set for allowing reverse or not. The result after adding will be
restricted by "Condition for negative frequency (reverse)"
Analog Input Gain (AVI)
Analog Input Gain (ACI)
Analog Positive Input Gain (AUI)
Analog Negative Input Gain (AUI)
Settings
Parameters 03-03 to 03-14 are used when the source of frequency command is the analog
voltage/current signal.
Analog Input Filter Time (AVI)
Analog Input Filter Time (ACI)
Analog Input Filter Time (AUI)
Settings
These input delays can be used to filter noisy analog signal.
When the setting of the time constant is too large, the control will be stable but the control
response will be slow. When the setting of time constant is too small, the control response will be
faster but the control may be unstable. To find the optimal setting, please adjust the setting
according to the control stable or response status.
0: Negative frequency is not valid. Forward and reverse run is controlled by
digital keypad or external terminal.
1: Negative frequency is valid. Positive frequency = forward run; negative
frequency = reverse run. Run direction can not be switched by digital
keypad or the external terminal control.
-500.0~500.0%
0.00~20.00 sec
12.1-03-19
Factory Setting: 0
Factory Setting: 100.0
Factory Setting: 0.01