Delta C2000 Series User Manual page 313

Chapter 12 Description of Parameter Settings
Reserved
Release Brake Check
Settings
The parameter needs to be used with MI=55. This is to be set for the time difference of
mechanical brake delay time and actual brake operation.
FWD ru n
c omma nd
Out put
frequ ency
MO= 63
MI= 55
Multi-function output terminal: Function 42: Brake Current Checking Point
Settings
Multi-function output terminal: Function 42: Brake Frequency Checking Point
Settings
Pr02-32, Pr02-33, Pr02-34, Pr02-57 and Pr02-58 can be applied on setting up cranes. (Choose
crane action #42 to set up multi-function output Pr02-13, Pr02-14, Pr02-16, and Pr02-17)
When output current of a drive is higher than the setting of Pr02-33 Pivot Point of the Current
(>=02-33) and when output frequency is higher than the setting of Pr02-34 Pivot Point of the
Frequency (>= 02-34), choose #42 to set up Multi-function output Pr02-13, Pr02-14, Pr02-16
and Pr002-17 after the delay time set at Pr02-32.
When the Pivot Point of the Current 's setting 02-57 0 and when the output current of the drive is
lower than the setting of Pr02-57 (<02-57), or when the output frequency is lower than the
setting of Pr02-58 (<02-58), the disable the setting #42 of the multi-function output Pr02-13,
Pr02-14, Pr02-16, Pr02-17
When Pr02-57 = 0, the output current is lower than setting of Pr02-33 Pivot Point of the current
(<02-33) or when output frequency is lower than the setting of Pr02-58(<02-58), disable the
setting of #42 of the multi-function output Pr02-13, Pr02-14, Pr02-16, Pr02-17.
0.000~65.000 sec.
Ou tput frequenc y> =Pr02 -3 4
and output curren t>= Pr0233
Pr02-32, brake delay time
Mechanical d ela y time
P r02-56, brak e-releas e ch eck ing time
0~100%
0.00~3.00Hz
12.1-02-27
Factory Setting: 0.000
No checking signal when
brake-release che ckin g time
is reach ed.
Factory setting: 0
Factory setting: 0.00