Delta C2000 Series User Manual page 222

Chapter 11 Summary of Parameter Settings
This chapter provides summary of parameter settings for user to gather the parameter setting ranges,
factory settings and set parameters. The parameters can be set, changed and reset by the digital keypad.
1 : the parameter can be set during operation
2 For more detail on parameters, please refer to Ch12 Description of Parameter Settings.
IM: Induction Motor; PM: Permanent Magnet Motor
Pr.
00-00
Identity Code of the AC Motor Drive
Display AC Motor Drive Rated
00-01
Current
00-02 Parameter Reset
00-03 Start-up Display Selection
Explanation
Chapter 11 Summary of Parameter Settings
Settings
575V:
505: 575V, 1.5KW, 2HP
506: 575V, 2.2KW, 3HP
507: 575V, 3.7KW, 5HP
508: 575V, 5.5KW, 7.5HP
509: 575V, 7.5KW, 10HP
510: 575V, 11KW, 15HP
511: 575V, 15KW, 20HP
690V:
612: 690V, 18.5KW, 25HP
613: 690V, 22 KW, 30HP
614: 690V, 30 KW, 40HP
615: 690V, 37 KW, 50HP
616: 690V, 45 KW, 60HP
617: 690V, 55 KW, 75HP
618: 690V, 75 KW, 100HP
619: 690V, 90 KW, 125HP
620: 690V, 110 KW, 150HP
621: 690V, 132 KW, 175HP
622: 690V, 160 KW , 215HP
686: 690V, 200 KW, 270HP
687: 690V, 250 KW, 335HP
626: 690V, 315 KW, 425HP
628: 690V, 400 KW, 530HP
629: 690V, 450 KW, 600HP
631: 690V, 560 KW, 745HP
632 690V, 630 KW, 850HP
Display by models
0: No function
1: Parameter write protect
5: Reset KWH display to 0
6: Reset PLC (including CANopen Master Index)
7: Reset CANopen Index (Slave)
8: No function
9: All parameters are reset to factory settings(base
frequency is 50Hz)
10: All parameters are reset to factory settings (base
frequency is 60Hz
0: F (frequency command)
1: H (output frequency)
2: U (multi-function display, see Pr.00-04)
3: A (output current)
11-1
Factory
Setting
Read
only
Read
only
0
0