Delta C2000 Series User Manual page 173

Chapter 8 Optional Cards
When VFD-C2000
parameters for it according to the table below. The EtherNet master is only able to read/write the
frequency word and control word of VFD-C2000
Parameter
P00-20
P00-21
P09-30
P09-75
P09-76
P09-77
P09-78
P09-79
P09-80
P09-81
P09-82
P09-83
P09-84
P09-85
P09-86
P09-87
1. Switch off the power supply of VFD-C2000
2. Remove the two screws (see Figure 6).
3. Twist opens the card clip and inserts the slot type screwdriver to the hollow to prize the PCB off the
card clip (see Figure 7).
4. Twist opens the other card clip to remove the PCB (see Figure 8).
[Figure 5]
is connected to EtherNet network, please set up the communication
(690V)
Function
Source of frequency
command setting
Source of operation
command setting
Decoding method for
communication
IP setting
IP address -1
IP address -2
IP address -3
IP address -4
Netmask -1
Netmask -2
Netmask -3
Netmask -4
Default gateway -1
Default gateway -2
Default gateway -3
Default gateway -4
after the communication parameters are set.
(690V)
Set value (Dec)
The frequency command is controlled by
8
communication card.
The operation command is controlled by
5
communication card.
The decoding method for Delta AC motor
0
drive
0 Static IP(0) / Dynamic distribution IP(1)
192 IP address 192.168.1.5
168 IP address 192.168.1.5
1 IP address 192.168.1.5
5 IP address 192.168.1.5
255 Netmask 255.255.255.0
255 Netmask 255.255.255.0
255 Netmask 255.255.255.0
0 Netmask 255.255.255.0
192 Default gateway 192.168.1.1
168 Default gateway 192.168.1.1
1 Default gateway 192.168.1.1
1 Default gateway 192.168.1.1
.
(690V)
8-34
Explanation