Delta C2000 Series User Manual page 304

Output for
52
communication card
53~64 Reserved
Output for CANopen and
65
RS485
66 SO contact A (N.O.)
68 SO contact B (N.C.)
Analog input signal level
67
achieved
Chapter 12 Description of Parameter Settings
For communication output of communication cards
(CMC-MOD01, CMC-EIP01, CMC-PN01 and CMC-DN01)
Setting of
Physical
related
terminal
parameters
RY1 P2-13 = 52
RY2 P2-14 = 52
MO1 P2-16 = 52
MO2 P2-17 = 52
MO10
P2-36=52
RY10
MO11
P2-37 = 52
RY11
RY12 P2-38 = 52
RY13 P2-39 = 52
RY14 P2-40 = 52
RY15 P2-41= 52
To be control output of CANopen & RS485.
Status of drive
Normal
STO
STL1~STL3
Multi-function output terminals operate when analog input signal
level is between high level and low level.
03-44: Select the analog signal channel, AVI, ACI, and AUI which
is going to be compared.
03-45: The high level of analog input, factory setting is 50%.
03-46: The low level of analog input, factory setting is 10%.
If analog input > 03-45, then multi-function output terminal
operates.
If analog input < 03-46, then multi-function output terminal stops
outputting.
12.1-02-18
Attribute Corresponding Address
RW
RW
RW
RW
RW
RW
RW
RW
RW
RW The bit 10 at 2640
Status of safety output
N.O. (MO=66)
Broken circuit
(Open)
Short circuit
(Close)
Short circuit
(Close)
The bit 0 at 2640
The bit 1 at 2640
The bit 3 at 2640
The bit 4 at 2640
The bit 5 at 2640
The bit 5 at 2640
The bit 6 at 2640
The bit 6 at 2640
The bit 7 at 2640
The bit 8 at 2640
The bit 9 at 2640
N.C. (MO=68)
Short circuit
(Close)
Broken circuit
(Open)
Broken circuit
(Open)