Delta C2000 Series User Manual page 496

16-3 Turn on
16-3-1 Connect to PC
Start operation of PLC functions in accordance with the following four steps
1. After pressing the Menu key and selecting 4: PLC on the KPC-CC01 digital keypad, press
the Enter key (see figure below).
NOTE
If the optional KPC-CE01 digital keypad is used, employ the following method:
Switch to the main PLC2 screen: After powering up the drivers, press the
switch to the function screen, which will then display "PrSET." After using the
"PLC" screen, and then press
"PLC2," and then press
currently has no program, and this error message can be ignored. If the PLC has an editing program, the screen will
display "End," and will jump back to "PLC2" after 1 to 2 seconds. When no program has been downloaded to the
drivers, the program can continue to run even if a PLC warning message appears.
2. Wiring: Connect the driver's RJ-45 communications interface to a PC via the RS485
Chapter 16 PLC Function Applications
to enter PLC function settings. Afterwards, press the Up key to switch to
. The screen will now display "PLSn" and flash, indicating that the internal PLC
16-5
C2000 Series
key on the KPC-CE01 once to
up or down button to switch to the