Delta C2000 Series User Manual page 290

Acceleration/deceleration
7
Speed Inhibit
st nd
The 1 , 2 acceleration
8 or deceleration time
selection
rd th
The 3 , 4 acceleration
9 or deceleration time
selection
EF Input
10
(EF: External fault)
External B.B. Input
11
(Base Block)
Output Stop
12
(Output pause)
Cancel the setting of the
13
optimal accel./decel. time
Switch between drive
14
settings 1 and 2
Operation speed
15
command form AVI
Chapter 12 Description of Parameter Settings
When this function is enabled, acceleration and deceleration is
stopped. After this function is disabled, the AC motor drive starts
to accel./decel. from the inhibit point.
The acceleration/deceleration time of the drive could be selected
from this function or the digital status of the terminals; there are 4
acceleration/deceleration speeds in total for selection.
For external fault input. Motor drive will decelerate by Pr.07-20
setting, keypad will show EF. (It will have fault record when external
fault occurs). Until the causes of fault are eliminated, the drive can
keep running after resetting.
When the contact of this function is ON, output of the drive will be
cut off immediately, and the motor will be free run and keypad will
display B.B. signal. Refer to Pr.07-08 for details.
If the contact of this function is ON, output of the drive will be cut off
immediately, and the motor will then be free run. And once it is
turned to OFF, the drive will accelerate to the setting frequency.
Before using this function, Pr.01-44 should be set to 01/02/03/04
first. When this function is enabled, OFF is for auto mode and ON is
for linear accel./decel.
When the contact of this function is ON: use motor 2 parameters.
OFF: use motor 1 parameters.
When the contact of this function is ON, the source of the frequency
will force to be AVI. (If the operation speed commands are set to
AVI, ACI and AUI at the same time. The priority is AVI ACI AUI)
12.1-02-4