Delta C2000 Series User Manual page 43

Chapter 3 Unpacking
Loosen 6 of the M6 screws on the side and removes the 2 plates, as shown in following figure. The
removed screws and plates can be used to secure AC motor drive from the external.
Loosen 18 of the M6 screws and remove the top
cover as shown in figure 2. Mount the cover (figure
1) back to the drive by fasten the M6 screws to the
two sides of the drive, as shown in figure 2.
Torque: 35~45kg-cm (30.38~39.06lb-in.)
(3.43~3.92 Nm)
Top cover (Use M12 screws)
Figure 1
Figure 2
Loosen 8 of the M8 screws on the both sides and
place the 2 plates that were removed from the last
step. Fix the plates to rive by fasten 8 of the M8
screws. (As shown in figure below).
Torque: 150~180kg-cm (130.20~156.24lb-in.)
(14.7~17.64 Nm)
3-10