Delta C2000 Series User Manual page 267

Chapter 12 Description of Parameter Settings
It is used to set the source of the master frequency in AUTO mode.
Pr.00-20 and 00-21 are for the settings of frequency source and operation source in AUTO mode.
Pr.00-30 and 00-31 are for the settings of frequency source and operation source in HAND mode.
The AUTO/HAND mode can be switched by the keypad KPC-CC01 or multi-function input
terminal (MI).
The factory setting of frequency source or operation source is for AUTO mode. It will return to
AUTO mode whenever power on again after power off. If there is multi-function input terminal
used to switch AUTO/HAND mode. The highest priority is the multi-function input terminal. When
the external terminal is OFF, the drive won't receive any operation signal and can't execute JOG.
Source of the Operation Command
Settings
It is used to set the source of the operation frequency in AUTO mode.
When the operation command is controlled by the keypad KPC-CC01, keys RUN, STOP and
JOG (F1) are valid.
Stop Method
Settings
The parameter determines how the motor is stopped when the AC motor drive receives a valid
stop command.
Output
Freq ue nc y
Moto r
Ro tatio n
Spe ed
Oper atio n
Co mmand
7: Reserved
8: Communication card (no CANopen card)
0: Digital keypad
1: External terminals. Keypad STOP disabled.
2: RS-485 serial communication. Keypad STOP disabled.
3: CANopen card
4: Reserved
5: Communication card (not includes CANopen card)
0: Ramp to stop
1:Coast to stop
Freq uen cy
Stops according t o
deceler ation time
RUN
STOP
Ra mp to Stop and Co ast to Sto p
12.1-00-10
AUTO
Freq uen cy
Output
Freq ue nc y
Moto r
Ro tatio n
Spe ed
Time
Oper atio n
RUN
Co mmand
Factory Setting: 0
Factory Setting: 0
Fr ee r unning
to stop
Time
STOP