Delta C2000 Series User Manual page 305

Chapter 12 Description of Parameter Settings
Example: Crane Application
Out put
freque ncy
Multi-func tion ou tput
MO=4 2 (Ac tive whe n
Fcom>= Pr02-34, outp ut
cu rren t >P r02-33,
time>P r0 2-32)
It is recommended to be used with Dwell function as shown in the following:
O utput frequen cy
Multi-function ou tput
MO=4 2 (Ac tive whe n
Fcom>= Pr02-34, outp ut
cu rren t >P r02-33,
time>P r0 2-32)
Multi-function Output Setting
Settings
The setting of this parameter is in hexadecimal.
This parameter is set via bit setting. If a bit is 1, the corresponding multi-function output acts in the
opposite way.
Example:
If Pr02-13=1 and Pr02-18=0, Relay 1 is ON when the drive runs and is open when the drive is
stopped.
If Pr02-13=1 and Pr02-18=1, Relay 1 is open when the drive runs and is closed when the drive is
stopped.
Bit setting
bit15 bit14 bit13 bit12 bit11 bit10
MO20 MO19 MO18 MO17 MO16 MO15 MO14 MO13 MO12 MO11 MO10 MO2 MO1 Reserved RY2 RY1
Outpu t freq uency>= Pr02-34
and out put current> =Pr02 -3 3
02-32
Set Pr07-16=P r02-34 and
outpu t current >= Pr0 2-33
Pr07-16
Dwell f requenc y
at acc el.
Pr02-32
Brak e delay time
0000h~FFFFh (0:N.O. ; 1:N.C.)
bit9
12.1-02-19
P r0 7-15
Dwell time
at ac cel.
bit8 bit7 bit6 bit5
Out put frequency< Pr02-58
or out put current <Pr02-57
02-32
Se t Pr07-18 =Pr02-58 and
out put current < Pr0 2-57
Pr07-18
Dwe ll f requenc y
at decel.
Pr07-17
Dwell t ime
at decel.
Pr02-32
Brak e delay time
Factory Setting: 0000
bit4 bit3 bit2 bit1 bit0