Figure 52: Dialog Window For Target System Settings - WAGO -I/O-SYSTEM 750 Manual

128 Programming the PFC Using WAGO-I/O-PRO
Additional Information:
For a detailed description of using the software, refer to the manual for the
"WAGO-I/O-PRO". This manual is located in the Internet under
http://www.wago.com.
Start the programming tool at Start \ Programs \ WAGO-I/O-PRO.
1.
Under File / New create a new project
2.
A dialog window then appears on which you can set the target system for
programming.

Figure 52: Dialog Window for Target System Settings

3. Select the respective entry in the select list for your fieldbus controller and
then click OK.
4. In the dialog window that appears select the program type (AWL, KOP,
FUP, AS, ST or CFC).
To ensure that you can access all I/O module data properly in your new project,
first compile the I/O module configuration based on the existing fieldbus node
hardware and map it in the configuration file "EA-config.xml".
This file defines whether write access is permitted to the modules from the IEC-
61131-3 program or from the MODBUS/TCP.
As described below, this file can be generated via configuration using the WAGO
I/O Configurator.
Manual
1.5.0
750-882 Media Redundancy ETHERNET Controller
WAGO-I/O-SYSTEM 750