Table of Contents
Advertisement
222 Run-time System CODESYS 2.3
8
Run-time System CODESYS 2.3
8.1
Installing the CODESYS 2.3 Programming System
The WAGO target files must also be included for the installation of CODESYS.
These contain all device-specific information for the WAGO 750/758 product
series.
Proceed as described below to install the CODESYS 2.3 programming software
on a personal computer.
1.
Insert the "WAGO-I/O-PRO" CD into your computer drive.
2.
To install the programming system, follow the instructions that appear on
your screen. A successful installation is indicated by a CODESYS icon on
your desktop.
8.2
First Program with CODESYS 2.3
This section uses an example to explain the relevant steps required for the
creation of a CODESYS project. It is intended as a set of quick start instructions
and does not address the full functional range of CODESYS 2.3.
Additional information
For a detailed description of the full range of functions, refer to the "Manual for
PLC Programming using CODESYS 2.3" manual available on the "WAGO-I/O-
PRO" (759-911) CD.
8.2.1
Start the CODESYS Programming System
Start CODESYS by double clicking on the CODESYS pictogram on your desktop
using the Start menu in your operating system. To do this, click on the "Start"
button and choose Programs >
WAGO Software > CODESYS > CODESYS V2.3.
8.2.2
Creating a Project and Selecting the Target System
In the menu bar click on File and select New. The "Target system settings"
1.
window then opens. Here, all available target systems that can be
programmed with CODESYS 2.3 are listed.
2.
Open the selection box in the "Target system settings" window and select
the fieldbus controller you are using. In the example show here this is the
PFC200 CS 2ETH RS 3G "WAGO_750-8207".
Manual
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
WAGO-I/O-SYSTEM 750
750-8207 PFC200 CS 2ETH RS 3G
Advertisement
Chapters
Table of Contents
Troubleshooting
