Diagnostic" Tab; Diagnostic Information" Page; Table 125: Wbm "Diagnostic Information" Page - WAGO Compact Controller 100 Manual

WAGO I/O System Compact
751-9301 Compact Controller 100
15.1.1.5

"Diagnostic" Tab

15.1.1.5.1 "Diagnostic Information" Page

The settings for displaying diagnostic messages are shown on the "Diagnostic
Information" page.

Table 125: WBM "Diagnostic Information" Page

Parameters
Read only the last
Automatic refresh interval
(sec)
To refresh the display or to enable cyclic refresh, click the [Refresh] button. This
button is only displayed if the cyclic refresh is not enabled.
To enable cyclic refresh, click the [Start] button. The button is only displayed if
cyclic refresh is enabled and has not yet started.
To stop cyclic refresh again, click the [Stop] button. The button only appears if
cyclic refresh is enabled.
The cyclical refresh is performed for as long as the "Diagnostic Information" page
is open. If you change the WBM page, the refresh is stopped until you call up the
"Diagnostic Information" page again.
The messages are displayed below the settings.
Meaning
Activate display of only the last n messages. You
also specify the number of messages to be
displayed.
Select the checkbox to enable cyclic refresh.
Enter the cycle time in seconds in which a cyclic
refresh is performed. The label of the button
("Refresh"/"Start"/"Stop") changes depending on
status.
Version 1.1.0, valid from FW Version 03.08.07(20)
Appendix 191
Manual