240 Appendix
"Diagnostic" Tab
15.2.1.5
15.2.1.5.1 "Diagnostic Information" Page
The settings for displaying diagnostic messages are shown on the "Diagnostic
Information" page.
Table 145: WBM "Diagnostic Information" Page
Parameters
Read only the last
Automatic refresh interval
(sec)
Source
To refresh the display or to enable cyclic refresh, click the [Refresh] button. This
button is only displayed if the cyclic refresh is not enabled.
To enable cyclic refresh, click the [Start] button. The button is only displayed if
cyclic refresh is enabled and has not yet started.
To stop cyclic refresh again, click the [Stop] button. The button only appears if
cyclic refresh is enabled.
The cyclical refresh is performed for as long as the "Diagnostic Information" page
is open. If you change the WBM page, the refresh is stopped until you call up the
"Diagnostic Information" page again.
The messages are displayed below the settings.
Manual
Version 1.7.0, valid from FW Version 04.01.10(23)
750-8210/040-000 PFC200; G2; 4ETH; XTR
Meaning
Activate display of only the last n messages. You
also specify the number of messages to be
displayed.
Select the checkbox to enable cyclic refresh.
Enter the cycle time in seconds in which a cyclic
refresh is performed. The label of the button
("Refresh"/"Start"/"Stop") changes depending on
status.
Select the source of the diagnostic messages.
The drop-down list depends on the user who is
logged in.
user
Default diagnostic messages only
Default diagnostic messages and all log
admin
files in the folder /var/log/*
WAGO I/O System 750