Holdtime - Cisco Nexus 7000 Series Command Reference Manual

holdtime

holdtime
To configure how long a Label Distribution Protocol (LDP) session is maintained in the absence of LDP
messages from the session peer, use the holdtime command. To return to the default setting, use the no
form of this command.
Syntax Description
seconds
infinite
Defaults 180 seconds
Command Modes LDP configuration mode
Supported User Roles
network-admin
vdc-admin
Command History Release
5.2(1)
Usage Guidelines This command requires the MPLS Services license.
Examples This example shows how long an LDP session is maintained in the absence of LDP messages from the
session peer:
switch(config)# mpls ldp configuration
switch(config-ldp)# holdtime 30
switch(config-ldp)#
Related Commands Command
mpls ldp configuration Configures the Multiprotocol Label Switching (MPLS) Label Distribution
Cisco Nexus 7000 Series NX-OS MPLS Command Reference
172
holdtime {seconds | infinite}
no holdtime
Hold time in seconds. The range is from 15 to 65535 seconds.
Specifies the LDP session holdtime.
Modification
This command was introduced.
Description
Protocol (LDP).
H Commands
OL-24994-01