Ipv6 Multicast Robustness - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

IP Multicast Switching Commands

ipv6 multicast robustness

Sets the MLD robustness variable on the specified VLAN or on the system if no VLAN is specified.
ipv6 multicast [vlan vid] robustness [robustness]
Syntax Definitions
vid
robustness
Defaults
parameter
robustness
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
IPv6 Multicast Switching and Routing must be enabled to set the MLD robustness variable on the
system and/or the specified VLANs.
•
If the MLD robustness variable is already configured on the system, then the VLAN configuration will
override the system's configuration.
•
Robustness variable allows fine-tuning on the network, where the expected packet loss would be
greater.
•
To restore the MLD robustness variable to its default (i.e., 2) value on the system if no VLAN is speci-
fied, use ipv6 multicast robustness followed by the value 0 (e.g., ipv6 multicast robustness 0) or use
only ipv6 multicast robustness (e.g., ipv6 multicast robustness).
•
To restore the MLD robustness variable to its default (i.e., 2) value on the specified VLAN, use
ipv6 multicast vlan vid robustness followed by the value 0 (e.g., ipv6 multicast vlan 2 robustness 0)
or use only ipv6 multicast vlan vid robustness (e.g., ipv6 multicast vlan 2 robustness).
Examples
-> ipv6 multicast robustness 3
-> ipv6 multicast robustness 0
-> ipv6 multicast robustness
-> ipv6 multicast vlan 2 robustness 3
-> ipv6 multicast vlan 2 robustness 0
-> ipv6 multicast vlan 2 robustness
Release History
Release 6.6.1; command was introduced.
OmniSwitch 6250 CLI Reference Guide
VLAN on which to apply the configuration.
MLD robustness variable. Valid range is 1 to 7.
default
2
November 2009 page 41-63