Vlan Ipmvlan Address - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

vlan ipmvlan address

Assigns an IPv4 address, IPv6 address, or a range of addresses to an existing IPMVLAN.
vlan ipmvlan ipmvlan-id address {ip_address | ipv6_address | ipaddress1-ipaddress2 | ipv6address1-
ipv6address2}
no vlan ipmvlan ipmvlan-id address {ip_address | ipv6_address | ipaddress1-ipaddress2 | ipv6address1-
ipv6address2}
Syntax Definitions
ipmvlan-id
ip_address
ipv6_address
ipaddress1-ipaddress2
ipv6address1-ipv6address2
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Use the no form of this command to disassociate the already assigned IP or IPv6 address from the
IPMV.
•
If the address is already assigned to another IPMVLAN, the configuration request will fail.
•
If you assign a range of addresses to an IPMVLAN, an error message will be displayed for the
addresses already assigned to the IPMVLAN.
•
A maximum of 128 addresses can be specified in a range. If the range is exceeded, configuration for all
the addresses in that range will fail.
Examples
-> vlan ipmvlan 1003 address 225.0.0.1
-> vlan ipmvlan 1033 address ff08::3
-> no vlan ipmvlan 1003 address 225.0.0.1
Release History
Release 6.6.1; command was introduced.
page 42-6
Specifies the IP Multicast VLAN number to which the IP address will
be assigned. The valid range is 2–4094.
Specifies a 32-bit IP Multicast address that will be assigned to the
IPMVLAN.
Specifies a 128-bit IPv6 Multicast address that will be assigned to the
IPMVLAN.
Specifies the IP Multicast address range.
Specifies the IPv6 Multicast address range.
OmniSwitch 6250 CLI Reference Guide
IP Multicast VLAN Commands
November 2009