Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual page 1805

IP Multicast Switching Commands
-> show ipv6 multicast vlan 1
Status:
Querying:
Proxying:
Spoofing:
Zapping:
Querier Forwarding:
Version:
Robustness:
Query Interval (seconds):
Query Response Interval (milliseconds):
Last Member Query Interval (milliseconds):
Unsolicited Report Interval (seconds)
Router Timeout (seconds):
Source Timeout (seconds):
output definitions
Status
Querying
Proxying
Spoofing
Zapping
Querier Forwarding
Version
Robustness
Query Interval (seconds)
OmniSwitch 6250 CLI Reference Guide
Whether the IPv6 Multicast Switching and Routing is Enabled or Dis-
abled (the default status).You can enable or disable IPv6 Multicast
Switching and Routing with the
which is described on page 41-37
The current state of MLD querying, which can be Enabled or Disabled
(the default status). You can enable or disable MLD querying with the
ipv6 multicast querying
The current state of MLD proxying on the system, which can be
Enabled or Disabled (the default status). You can enable or disable
MLD spoofing with the ipv6 multicast proxying
described on page 41-69
The current state of MLD spoofing on the system, which can be
Enabled or Disabled (the default status). You can enable or disable
MLD spoofing with the ipv6 multicast spoofing
described on page 41-31
The current state of MLD zapping on the system, which can be
Enabled or Disabled (the default status). You can enable or disable
MLD zapping with the ipv6 multicast zapping
described on page 41-67
The current state of MLD querier forwarding on the system, which can
be Enabled or Disabled (the default status). You can enable or disable
MLD Querier forwarding with the
command, which is described on
Displays the default MLD version, which can be 1, 2 or 3. Use the
multicast version command to modify this parameter.
Displays the MLD robustness value, ranging from 1 to 7. Use the
multicast robustness command to modify this parameter.
Displays the time (in seconds) between MLD queries. (The default
value is 125 seconds). You can modify this parameter with the
ipv6 multicast query-interval
41-49.
November 2009
= Enabled
= Disabled
= Disabled
= Disabled
= Disabled
= Disabled
= 1
= 2
= 125
= 10000
= 1000
= 1,
= 90
= 30:
ipv6 multicast status
command, which is described on
command, which is
command, which is
ipv6 multicast querier-forwarding
page 41-39.
command, which is described on
command,
page 41-61
command, which is
ipv6
ipv6
page
page 41-87