Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual page 1791

IP Multicast Switching Commands
output definitions
Query Interval (seconds)
Query Response Interval
(tenths of seconds)
Last Member Query Interval
(tenths of seconds)
Unsolicited Report Interval
(seconds)
Router Timeout (seconds)
Source Timeout (seconds)
Release History
Release 6.6.1; command was introduced.
OmniSwitch 6250 CLI Reference Guide
Displays the time (in seconds) between IGMP queries. (The default
value is 125 seconds). You can modify this parameter with the
ip multicast query-interval
41-15.
Displays the time (in tenths of seconds) taken to reply to an IGMP
query message. (The default value is 100 tenths-of-seconds). You can
modify this parameter with the
command, which is described on
Displays the time (in tenths of seconds) taken to reply to an IGMP
query message sent in response to a leave group message. (The default
value is 10 tenths-of-seconds.) You can modify this parameter with the
ip multicast last-member-query-interval
described on page 41-17.
Displays the time period (in seconds) to proxy any changed IGMP
membership state. (The default value is 1 second). You can modify this
parameter with the ip multicast unsolicited-report-interval
mand, which is described on
Displays the IGMP router timeout in seconds. (The default value is 90
seconds.) You can modify this parameter with the
ip multicast router-timeout
41-23.
Displays the IGMP source timeout in seconds. (The default value is 30
seconds.) You can modify this parameter with the
ip multicast source-timeout
41-25.
November 2009
command, which is described on
ip multicast query-response-interval
page 41-19.
command, which is
page 41-21.
command, which is described on
command, which is described on
page
com-
page
page
page 41-73