Events And Event Properties; Data Pattern Mask And Match - Teledyne Sierra M6-2 User Manual

Teledyne LeCroy

5.15.5 Events and Event Properties

Generation rules are associations between events and actions. These associations
determine how trace recording occurs. The supported events are:

Data Pattern Mask and Match

If you select Data Pattern as the Event, you can set Data Pattern event properties in the
Event Properties dialog.
Figure 5.24: Event Properties for Data Pattern Event
In the Data Pattern dialog, you can set the DWORD. You can set the Offset by entering an
integer. Optionally click the Sequential Offsets checkbox.
504
Primitives: Primitive Categories or Primitive

Frames: Open Address Frames, Identify Address Frames,

Zone Broadcast Address Frames, SSP Frames, or SMP Frames
SCSI Commands

SCSI Status

SATA FIS: Register Host to Device, Register Device to Host, Set Device Bits, DMA

Activate, DMA Setup, BIST Activate, PIO Setup, Data, Route, or Vend FIS
SSP Frame Header: DATA, XFER_RDY, COMMAND, RESPONSE, TASK, VENDOR, or

RESERVED
SSP Information Unit: Command IU, Task IU, XFER_RDY IU, or Response IU

SMP Request/Response: RPT_GENERAL, RPT_MFG_INFO, DISCOVER, RPT_‐

PHY_ERR_LOG, RPT_PHY_SATA, RPT_RT_INFO, CONFIG_RT_INFO, PHY_CON‐
TROL, PHY_TEST_FUNCTION, CONFIG_PHY_ZONE, CONFIG_ZONE_PERM,
RPT_ZONE_PERM, or RPT_ZONE_RT_TBL
ATA Commands

ATAPI Commands

SATA Data Pattern

SAS Data Pattern

Sierra M6‐2 SAS/SATA Protocol Analyzer User Manual
Generation Options