Sas Commands Errors (Sas Only) - Teledyne Sierra M6-2 User Manual

Teledyne LeCroy

2.12.4 SAS Commands Errors (SAS only)

Click the SAS Commands icon in the Errors window to display the
Commands Error Setting dialog.
Status
Indication
Figure 2.209: SAS: SAS Commands Error Setting Dialog
1. Click the SSP, SMP or Task option button to display the commands available for each
2. Click a command for which to set an error, check the Generate Error when: check
Command number specifies the number of the command for which you want to inject
error. For example, if you select the Inquiry command, then enter 2 for the Command
Number, you inject error on the 2nd Inquiry command.
Number of error commands specifies the number of commands for which you want to
inject error. For example, if you select the Inquiry command, then enter 2 for the
Command Number, and enter 3 for Number of Error Commands, the target emulator
injects error on the 2, 3, and 4 Inquiry commands, because you want to inject on 2nd
command and continue error injection as much as 3 times.
When using Command Number as the Error Injection filter, you can repeat the erring‐
command sets by checking Repeat error. The default value is 1, which injects error only
once, with no repeats. In the above example, the system injects error on the 2, 3, and 4
Inquiry commands and does not inject error for other commands.
If you enter 2 for Repeat Error, the system injects error on the 2nd, 3rd, 4th, 6th, 7th, and
8th commands.
If you enter 3 for Repeat Error, target emulator injects error on the 2nd, 3rd, 4th, 6th, 7th,
8th, 10th, 11th, and 12th commands.
196
of these categories in the Event Selection window.
box, then enter values for LBA, TAG, or Command number in the corresponding text
box.
Target and Device Emulation
Sierra M6‐2 SAS/SATA Protocol Analyzer User Manual