Teledyne Sierra M6-2 User Manual page 164

Teledyne LeCroy
Figure 2.172: SAS: PHY Setting Dialog
Select the port speed settings (see
After you click OK, you can Enable Muxing On.
Pattern Generator
You can select a Pattern Generation file.
Initiator Emulator
You can run an Initiator Emulator while setting:
Check Autostop Exerciser when Analyzer Stopped to halt the Initiator Emulator when
the Analyzer stops. If unchecked, the Exerciser continues to run even after the Analyzer
stops.
Check Autostop Analyzer when Exerciser Stopped to halt the Initiator Emulator when
the Exerciser stops. If unchecked, the Exerciser continues to run even after the Exerciser
stops.
162
Auto stop Exerciser when Analyzer stopped

Auto stop Analyzer when Exerciser stopped

Auto update "Sector Count/Transfer Len" before running

SAS Address

Data Frame Payload Size

Frame Receive Timeout

Logical Block Size

ATA Command Execution Timeout

Send NOTIFY ENABLE SPINUP primitive

"PHY Setting Dialog" on page
Sierra M6‐2 SAS/SATA Protocol Analyzer User Manual
Emulation
136).