Teledyne Sierra M6-2 User Manual page 475

Sierra Trainer Generation Commands
CONNECT
DISCONNECT
PAUSE
OUTPUT_ON
OOB Commands
COMINIT
COMRESET
COMWAKE
COMSAS
SATA_ALIGN
SATA_D10_2
SPEED_NEG_RCDT
SPEED_NEG_ALIGN0
SPEED_NEG_ALIGN1
Sierra M6‐2 SAS/SATA Protocol Analyzer User Manual
Generator will go through connection
sequence using current GenFile settings
(gen mode, speed, and so on). Generation
will not resume until connection is
established.
Generator will break existing connection to
DUT.
Generator will come to a break and the
user will be able to resume generation by
pressing Resume button on Generation
toolbar. Generator shall transmit idle
s while in the Pause.
DWORD
Takes the Trainer out of Electric Idle state. If
it is already out of Electric Idle, this is a
NOP.
Generator will send COMINIT OOB signals
using current COMINIT settings.
Generator will send COMRESET OOB signals
using current COMRESET settings.
Generator will send COMWAKE OOB signals
using current COMWAKE settings.
Generator will send COMSAS OOB signals
using current COMSAS settings.
Generator will go through SATA_ALIGN
stage of SATA SpeedNeg process using
current SATA_ALIGN settings.
Generator will go through SATA_D10_2
stage of SATA SpeedNeg process using
current SATA_D10_2 settings.
Generator will go through
SPEED_NEG_RCDT stage of SAS SpeedNeg
process using current SPEED_NEG_RCDT
settings.
Generator will go through
SPEED_NEG_ALIGN0 stage of SAS
SpeedNeg process using current
SPEED_NEG_ALIGN0 settings.
Generator will go through
SPEED_NEG_ALIGN1 stage of SAS
SpeedNeg process using current
SPEED_NEG_ALIGN1 settings.
Teledyne LeCroy
473