Teledyne Sierra M6-2 User Manual page 170

Teledyne LeCroy
Check Autostop Analyzer when Exerciser Stopped to halt the Initiator Emulator when
the Exerciser stops. If unchecked, the Exerciser continues to run even after the Exerciser
stops.
Check CONT Usage to enable the specification of Delay between getting HOLD to
sending HOLDA, Data Frame Payload Size, and ATA Command Execution Timeout.
Check Auto update "Sector Count" before running ‐ If you want to automatically
calculate the sector count and transfer length per the payload data length. Keep this
unchecked to use the values entered manually in the emulation script.
Note:
Checking this option will manipulate the emulation script with the calculated values, but
unchecking it afterwards will NOT revert to the previous values. It is recommended to save a
copy of your script before checking this option. The message shown in
displays when you check this option.
Figure 2.179: Auto Update Message
ATA Command Execution Timeout
The ATA Command Execution Timeout is a timeout for ATA commands. When the host
sends an H2D frame (i.e., it issues a command) and receives an R_OK from the device, it
starts this timer. If the execution of the command takes more than the timeout specified
(15 seconds is the default), the host emulator performs the action specified in the
Advanced/General/ ATA command timeout recovery action settings. The options are
Nothing, Send Soft Reset and Hard Reset.
Queue Settings
Click the Queue Settings button to display the Queue Settings dialog (see
page
168
169)and specify:
Queue Depth

NCQ Error Recovery

Queued/Non‐Queued Items Status

NCQ/Queue Command Timeout

Figure 2.179 on page 168
Sierra M6‐2 SAS/SATA Protocol Analyzer User Manual
Emulation
Figure 2.180 on