Other - Teledyne Sierra M6-2 User Manual

Preferences Teledyne LeCroy

Other

Switch to CATC Navigation: Packet view will open in CATC mode.
Reverse Link Data: The software shows DWORDs of link data as reversed.
Pack Repeated Primitives: The software packs repeated primitives just after opening a
sample file.
Scroll Horizontally to Show matched Column in Search: When unchecked makes columns
stationary even during search.
Use new PHY capabilities decoding: Checking this box sends the first bit as bit # 7.
Leaving the box unchecked sends the first bit as bit # 0.
Cancel button kills upload immediately: The software kills the uploading process if you
press Cancel.
Close previous sample file when new sample file opens: When you want to open a new
sample file, the software closes any open sample files.
Create statistical report read/write page: The software creates a Read/Write page in the
statistical report. Enabling this setting displays the Read/Write Stream DMA command in
the Read/Write page.
Show Quick View Warning: The Quick View Warning pops up when attempting to close a
trace that has not yet been saved, and is only shown in Quick View "mode". This checkbox
allows to turn off this popup.
LBA mode: Checking this box enables LBA mode for ATA decoding.
CHS mode: Checking this box enables CHS mode for ATA decoding.
According to LBA mode in ATA command: Checking this box enables decoding according
to LBA mode in ATA command for ATA decoding.
Configuration: Clicking Configuration displays the Trace Viewer Configuration dialog (see
Figure 3.143 on page 330).
Sierra M6‐2 SAS/SATA Protocol Analyzer User Manual 329