Record And Play - Teledyne Sierra M6-2 User Manual

Teledyne LeCroy
Figure 2.150: SAS: Active SAS Addresses
3. To assign commands to an active address, right‐click an address and choose:
Note:
Selecting a SAS device and clicking Export allows you to export in .std format. Selecting a SATA or
Expander and clicking Export allows you to export in .txt format.
2.9.3

Record and Play

This feature allows the selection of a range of commands in a trace and exports them to a
previously saved *.sac file for execution by the SAS Initiator Emulator or *.stc file for
execution by the SATA Host Emulator. You can export commands from all available
samples, between X and Y cursors, or between designated commands.
To perform this action:
1. Run a capture project or open a previously run and saved a captured trace file.
2. Set X and Y cursors to export between cursors (see
144
Insert To Cursor assigns all commands up to the cursor to the chosen address.
Insert: To All assigns all commands to the chosen address.
Figure 2.151 on page
Sierra M6‐2 SAS/SATA Protocol Analyzer User Manual
Emulation
145).