Teledyne Sierra M6-2 User Manual page 122

Teledyne LeCroy
Figure 2.109: SAS: Choosing a Trigger Condition
2. Define each selected pattern in the same way as in Easy Mode, as described starting
Note:
You can set a timer for any If or Else If condition.
3. Enter a value for the number of occurrences before trigger in the Cont field, up to a
4. Choose a capture option: Everything, Nothing, or Pattern.
5. If you choose Pattern, you can select patterns for inclusion or exclusion. Clicking the
Figure 2.110: SAS: Choosing a Pattern
6. Choose pattern(s) and click the +>> button to add them for capture or exclusion. You
7. For an output trigger, click the down arrow in the Ext. Out field and choose an
8. To go to another state, click the down arrow in the Go To field and select a state. If
120
on page 69. To use a timer, define it first.
maximum of 65535 occurrences.
Pattern option enables a pattern definition dialog (see
define each pattern the same way as in Easy mode (see
page 69).
output trigger level. Note: Do not use the LOW setting in Advanced Mode.
no other state has been defined, choose New State to add a state.
Advanced Mode (User‐Defined)
Figure 2.110 on page
"Defining Patterns" on
Sierra M6‐2 SAS/SATA Protocol Analyzer User Manual
120).