Analysis
Figure 3.40: Primitive Report
Bus Condition Report
To display the Bus Condition Report (see
tab. The Bus Condition Report displays information in the following columns.
Figure 3.41: Bus Condition Report
ATA Command Report
To display the ATA Command Report, click the ATA Command tab (see
page
Sierra M6‐2 SAS/SATA Protocol Analyzer User Manual
Bus Condition: All, Custom, Activity On, COMININT/COMRESET, COMSAS, COM‐
WAKE, Keep Alive Activity
Direction: All, H‐>D, D‐>H, I‐>T, T‐>I, or Custom
Count: All, Custom, or a number of occurrences
%: of total count
250.) The ATA Command Report displays information in the following columns:
Command: All, Custom, Check Power Mode, Execute Device Diagnostic,
Flush Cache, Identify Device, Read DMA Ext, Read FPDMA Queue, Set Feature,
Write DMA Ext, Write FPDMA Queue
PM Port
Direction: All, H‐>D, D‐>H, I‐>T, T‐>I, or Custom
Number of FIS: All, Custom, or a number
Payload Size: All, Custom, or a number of DWORDs
Figure 3.41 on page
249), click the Bus Condition
Teledyne LeCroy
Figure 3.42 on
249