Vendor; Trigger Setup - Teledyne Sierra M6-2 User Manual

Projects

Vendor

Vendor is for FIS Pattern.
Figure 2.62: Vendor

2.6.16 Trigger Setup

The Trigger tab in the analysis project dialog allows you to specify when the analyzer
completes a data capture. Three trigger modes are available:
When data capture starts with Don't care (Snapshot) selected, the analyzer triggers on
the first data pattern on the bus.
Starting a data capture with Pattern selected triggers when specific pattern(s) are
detected in the captured data stream. The following three ways can trigger the analyzer
with Pattern selected.
Sierra M6‐2 SAS/SATA Protocol Analyzer User Manual
Don't care (Snapshot) is the default

Manual Trig

Pattern

Trigger on any pattern (Any Trigger Mode)

External Trigger

Trigger on a sequence of patterns (Sequential Trigger Mode)

Teledyne LeCroy
81