Generate Menu - Teledyne Sierra M6-2 User Manual

Sierra Trainer Menus
Note:
See "Multi‐Port Trainer Script Assignments to Links" on page
Display Options: Selects what information to display. See
Figure 5.3: Trainer Setup Menu.
5.1.3

Generate Menu

Start Generation: Causes the Generator to begin generation.
Stop Generation: Causes the Generator to stop generation.
Resume Generation: Causes the Generator to resume generation after a stop.
Connect Link: Automatically bring the linkup to the Host, Device, Initiator, or Target
connected to the Generator.
Disconnect Link: Disconnect link.
Connect Parameters: Set the "Identify" frame parameter settings to keep the link
connected. See
Generation Options: Setup the Generation Rules. See
497.
Sierra M6‐2 SAS/SATA Protocol Analyzer User Manual
configuration in both of them. See
describes possible configurations:
Analyzer and Trainer on same port: You can generate initiator/target traffic

and also capture the traffic generated.
Analyzer and Trainer on same port, and Analyzer and Trainer on another

port: You can generate initiator/target traffic and also capture the traffic gen‐
erated on two ports.
Trainer on one port, and Analyzer on another port: Trainer is run on a port

generating initiator/target traffic and Analyzer is run on the other port cap‐
turing the traffic.
Trainer and Jammer on same port: You can generate initiator/target traffic

and also inject errors on the traffic between initiator and target on the port.
"Connection Parameters" on page
"Ports Configuration" on page
455.
"Display Options" on page
515.
"Auto Speed Negotiation" on page
Teledyne LeCroy
112. The following
510.
437