Scsi Command Report (Sas); Smp Command Report (Sas); Task Command Report (Sas) - Teledyne Sierra M6-2 User Manual

Analysis

SCSI Command Report (SAS)

To display the SCSI Command Report, click the SCSI Command tab. The SCSI Command
Report displays (see
following information:
Figure 3.49: SAS: SCSI Command Report

SMP Command Report (SAS)

To display the SMP Command Report, click the SMP Command tab. The SMP Command
Report displays the report data in columns with the following information:
Figure 3.50: SAS: SMP Command Report

Task Command Report (SAS)

To display the Task Command Report, click the TASK Command tab. The Task Command
Report displays the report data in columns with the following information (see
Figure 3.51 on page
Sierra M6‐2 SAS/SATA Protocol Analyzer User Manual
Figure 3.49 on page
Command: All, Custom, Inquiry, Mode Sense6, Pause Resume, Play Audio 10,

Read Capacity, Read10, Receive Diagnostic Results, Send Diagnostic, Write10,
Start Stop Unit, Test Unit Ready, Report Luns, Synchronize Cache10
Direction: All, I‐>T, T‐>I, or Custom

Number of Transport: All, Custom, or a number

Payload Size: All, Custom, or a number of DWORDs

Status: All, Custom, Good, Incomplete, Response Data Present

Task Attribute: Simple

Duration: All, Custom, or time unit

Count: All, Custom, or a number

%: of total count

Function: All, Custom, Discover, Report General,

Report Manufacture Information, Report PHY Error Log
Function Result: SMP Function Accepted

Direction: All, I‐>T, T‐>I, or Custom

Duration: All, Custom, or time unit

Count: All, Custom, or a number

%: of total count

254):
253) the report data in columns with the
Teledyne LeCroy
253