Resetting The Toolbar - Teledyne Sierra M6-2 User Manual

Teledyne LeCroy
Figure 5.33: Connection Parameters Dialog
You can set the "Identify" frame parameter settings to keep the link connected:
You can select to not show the dialog until there is a generation mode change.
5.20

Resetting the Toolbar

The Analyzer Toolbar has the following:
The Generator Toolbar has the following:
516
Device Type: End Device, Edge Expander, or Fanout Expander

SSP Initiator: Present or Not Present

STP Initiator: Present or Not Present

SMP Initiator: Present or Not Present

SSP Target: Present or Not Present

STP Target: Present or Not Present

SMP Target: Present or Not Present

SAS Address (hex): eight digits ‐ eight digits

PHY Identifier (hex): two digits

Zone Device: Yes or No

Zone Broadcast Method (hex): two digits

Show InFusion Frame: Switches to InFusion frame.

Show Analyzer Frame: Switches to Analyzer frame.

Start Analyzer: Start Analyzer without switching to Analyzer frame.

Stop Analyzer: Stop Analyzer without switching to Analyzer frame.

Abort Analyzer: Abort Analyzer without switching to Analyzer frame.

Sierra M6‐2 SAS/SATA Protocol Analyzer User Manual
Resetting the Toolbar