Viewing Captured Data - Teledyne Sierra M6-2 User Manual

Teledyne LeCroy SAS/SATA Protocol Suite Menu Options and Toolbars
Figure 1.23: SAS/SATA Analysis Menu

1.21.5 Viewing Captured Data

Captured data can be displayed in several views. Select Analysis from the drop‐down
menu to access the different views (see
data in:
Sierra M6‐2 SAS/SATA Protocol Analyzer User Manual
Packet View: Displays packets

Spreadsheet View: Displays Packet View fields by time

Column View: Shows DWORDs in columns by port

Text View: Shows transaction frames, grouped in columns by port

Frame Inspector View: Has lots of information that is available in Packet View,

but not Spreadsheet View, so it is most useful in conjunction with the Spread‐
sheet View.
Waveform Display: Shows waveform display for all active ports, on which you

can perform timing measurements
Statistical Report: generate statistics for all transports, commands, primitives,

bus conditions, addresses, lanes, and errors
Histogram View: Shows frame‐type transfers

Bus Utilization: Displays the utilization of the bus

Data Reports: Displays data payloads

Compare 2 Data Payloads: Compares two data payloads

SAS Verification: Verifies compliance with the SAS specification

Compliance Test: Verifies compliance with the SATA specification

VSE: Perform custom post‐process analysis of the open trace by running a verifi‐

"Analysis" on page 224). You can display the same
Teledyne LeCroy
43