Multi-Port Trainer Script Assignments To Links - Teledyne Sierra M6-2 User Manual

Multi‐Port Trainer Script Assignments to Links Teledyne LeCroy
5.10

Multi-Port Trainer Script Assignments to Links

If more than one port of Trainer is licensed, after you open a generator file (.ssg) or create
a new generator file ("Creating a Traffic Generation File" on page 442), you can assign
scripts to one or more ports.
Click the Port Configuration button to open the Set Port Configuration dialog
(see "Ports Configuration" on page 112). Select a port configuration. For example, Trainer
may be on Port1 and Port 2 or Port3 and Port4.
After you select port configuration, the Assign Active Script/Remove Assigned Script for
Link 1, 2, 3, or 4 buttons have colors. For example, for Trainer on Ports 1 and 2, the
buttons are
.
After you open or create a script in the Trainer window, click the L1 or L2 button to assign
the script to Port 1 or Port 2. A display appears to the left of the script in the Trainer
window.
That link now has link‐specific Start, Stop, Resume, Connect, and Disconnect buttons. (See
the previous page for the button descriptions.)
Use the link‐specific buttons to control each link separately.
You can click the L1 or L2 button again to remove the script from the link.
After you select port configuration, the Trainer toolbar changes to display the Generation
buttons Start All Generation, Stop All Generation, Resume All Generation,
Connect All Link, and Disconnect All Link.
Use these buttons to control all links.
You can click the Link Script Selection script assignment dialog.
to open
Sierra M6‐2 SAS/SATA Protocol Analyzer User Manual 455