Use Pair Sas Addresses; Training Sequence; Selectable Filter Options For Sata - Teledyne Sierra M6-2 User Manual

Teledyne LeCroy

Use Pair SAS Addresses

You can use all available pair SAS addresses (Source ‐> Destination) instead of using SAS
source and destination addresses. To enable the pair SAS address filter option, check Use
Pair SAS Addresses check box in the Filter dialog.
Figure 3.105: SAS: SAS Address Filtering before and after Using Pair SAS Addresses
Note:
If you enable pair SAS addresses, the source/destination SAS addresses options are disabled and
filtering on them is ignored at filtering time. If you disable pair SAS addresses, the pair SAS
address option is disabled and filtering on it is ignored at filtering time.

Training Sequence

When selected, depending on the Filter Type, the Hide/Show selection shows or hides
captured Training Sequences in the Sample Viewer.
3.8.5

Selectable Filter Options for SATA

The SATA filter options are:
296
Bus Condition

Incomplete Frames

FIS

ATA Command

Protocol Error

Port

ATAPI SCSI Command

Miscellaneous

Filter Idle (see Figure 3.104 on page

295)
Sierra M6‐2 SAS/SATA Protocol Analyzer User Manual
Navigation + View Toolbar