Teledyne Sierra M6-2 User Manual page 36

Teledyne LeCroy
2. Insert the extraction‐tool prongs into the holes in the expansion card panel.
Note:
If the prongs do not slip easily into the holes, use a small nail file or similar device to remove
paint from the prongs.
3. Rotate the extraction tool to a horizontal position to lock the prongs into place and
4. Using the screwdriver, loosen both retaining screws by rotating them counter‐
34
make a handle.
clockwise approximately two full turns, until feeling slight resistance. Do not force
the retaining screws after two turns.
Holes in the
Expansion Card
Sierra M6‐2 SAS/SATA Protocol Analyzer User Manual
Expandability