Project Tree; Capture Tab Fields; Exclude Xxxx - Teledyne Sierra M6-2 User Manual

Project Tree

SAS vs. SATA: SATA Dialog does not show "Exclude RRDY" or "Exclude NOTIFY".
SATA Dialog replaces "Exclude SATA_CONT" with "Exclude CONT" and
"Exclude SATA_SYNC" with "Exclude SYNC".
2.3 Project Tree
The Project Tree on the right side of the main window displays a comprehensive tree
structured overview of the project. The project tree shows the capture configuration,
trigger setups, and the capture memory settings.
2.3.1

Capture Tab Fields

The Capture tab has the following fields:
Exclude SATA_CONT (SAS) or Exclude CONT (SATA)
Check this to exclude SATA_CONT primitives from the data capture.
Exclude SATA_SYNC (SAS) or Exclude SYNC (SATA)
Check this to exclude SATA_SYNC primitives from the data capture.
Exclude OOB Signals
Check this to exclude OOB signals from the data capture.

Exclude XXXX

Check this to exclude XXXX patterns from the data capture.
Note:
The validity of time stamps during Idles is traded off against good buffer memory utilization
when using 'Exclude XXXX'.
Exclude Dev Slp Packets (SATA)
Check this to exclude Dev Slp Packets from the data capture.
Exclude Payload except
Check this to exclude Payload of Data Frames from the data capture. You can except a
number of DWORD(s).
Note:
The Data Report (refer to
Frames.
Note:
When showing truncated data in the Data Payload View, the truncation points are marked with
a separator placed between payloads. You can get more information about the data exclusion
using the tooltip over the separator.
Exclude ALIGN
Check this to exclude ALIGN primitives from the data capture.
Sierra M6‐2 SAS/SATA Protocol Analyzer User Manual
"Data Report" on page 269) does not reflect excluded Payload of Data
Teledyne LeCroy
51