Power Expansion Card 2 (Part Number: Acc-Exp-005-X) - Teledyne Sierra M6-2 User Manual

Teledyne LeCroy
You can turn the card on or off through the software during SATA Compliance or
SAS Verification tests.
You can turn the card on or off through the BusEngine by user‐emulation scripts during
Emulation.
Power Expansion Card 2
This card has several capabilities:
32
(part number: ACC‐EXP‐005‐X)
Supplies power to devices at 12v, 5v, 3.3v, 1.5v and/or 1.2v. This is controlled by

the application (see
Allows toggling the new "Device Sleep" (DevSlp) signal to put SATA devices into

sleep (see "Adding an Event" on page 134
Allows monitoring in the trace of the DevSlp signal as generated by the Trainer

or Host Emulator, as well as when generated directly from a Host (using a dedi‐
cated DevSlp cable). Also see
Allows CATC Sync functionality to enable cascading, so there is no need to toggle

between the Power Expansion Card and the Sync Expansion Card.
Allows power measurement to monitor and record the power, current and volt‐

age being used by the device it powers (will be supported in a future software
release).
"Power On" on page 135).
and
"Device Sleep (DevSlp)" on page
Sierra M6‐2 SAS/SATA Protocol Analyzer User Manual
Holes in the
Expansion Card
Figure 2.129 on page
232.
Expandability
135).