Teledyne Sierra M6-2 User Manual page 279

Compliance Test (SATA)
1. Select Analysis on the main toolbar and choose Compliance Test to open the SATA
Figure 3.85: Compliance Test Dialog
The Phy Test and Digital Test groups are displayed in the left column. The Digital Tests
comprise of the following:
2. Choose the tests in the left pane of the dialog by clicking on the checkboxes and click
Sierra M6‐2 SAS/SATA Protocol Analyzer User Manual
Compliance Test dialog (see
General Device Requirements

Native Command Queuing

Asynchronous Signal Recovery

Software Settings Preservation

Interface Power Management

the Add>> button.
You can add all or remove all by clicking Add All or Remove All.
Figure 3.85 on page 277).
Teledyne LeCroy
277