Using The Viewer Display; Trace Properties - Teledyne Sierra M6-2 User Manual

Trace Properties

3.1.3

Using the Viewer Display

To configure the data viewer display, use the toolbars. You can display the same data in:
To change the view type when opening a trace, change the default workspace or save
options in the Preferences dialog.
To toggle among open windows, use CTRL ‐ TAB.
To reverse toggle order, use CTRL ‐ SHIFT ‐ TAB.
To make a frame a trigger pattern, in Packet View, right‐click any frame, select
Add to Trigger, and add the pattern to DataPatternCapture.
Viewer Display enables you to also perform the following:
3.2 Trace Properties
You can view the Trace Properties from the File menu. Click File > Trace Properties, the
Trace Properties dialog displays with the following information (see
page
Sierra M6‐2 SAS/SATA Protocol Analyzer User Manual
Packet view

Spreadsheet view

Column view, with transactions grouped for each active port

Text view, with transactions grouped for each active port

Waveform view

Frame Inspector view

Histogram view

Bus Utilization view

Data Report

Statistical Report view

Decode Assignments (Refer to

details.)
Compare Two Data Payloads (Refer to

page 272 for more details.)
Run Verification Scripts (Refer to

page 278 for more details.)
224):
Software version

Sample file version

Grouping Type

Hardware bin file version

Analyzer armed at

Analyzer triggered at

Sample saved at

Original Capture Project: Open displays the project settings used to capture the

sample.
Licensing Information

Simpass Information

"Decoding Assignments" on page 225
"Compare Two Data Payloads" on
"Running Verification Script Engine (VSE)" on
Teledyne LeCroy
for more
Figure 3.3 on
223