Address Frame; Sas Data Pattern; Sata Data Pattern - Teledyne Sierra M6-2 User Manual

Teledyne LeCroy
When you create a DWORD match, keep the following in mind:
4.7.2

Address Frame

With Infusion, you must enter all values in reverse MSB, LSB order.
For example: a SAS Address in the viewer "5000C50056B8C829" should be entered like
this in Infusion: "29C8B85600C50050".
4.7.3

SAS Data Pattern

When you create a SAS data pattern, keep the following in mind:
For example, for an SMP Request:
Pattern: 0x40000000
Mask: 0xFF000000
Offset: 0
SOF Type: SOF
4.7.4

SATA Data Pattern

When you create a SATA data pattern, keep the following in mind:
388
The pattern can be inside or outside of frames (it does not matter if the pattern

is inside a frame or not).
Because the pattern can be inside or outside of frames, there is no offset.

You can make user‐defined primitives. (This is the reason this feature was cre‐

ated.)
You can use any K/D pattern.

The pattern must be defined inside a frame that starts with a SOF or SOAF.

The pattern must be data only (no K‐codes/primitives).

The pattern must be defined at a specific offset in the frame.

The pattern and mask must be specified in the same format as specified in the

SAS standard:
0x12345678 (hex)
where "1" is the first digit on the cable and is the MSB as given in the SAS Stan‐
dard.
The pattern must be defined inside a frame that starts with a SATA_SOF.

The pattern must be data only (no K‐codes/primitives).

The pattern must be defined at a specific offset in the frame.

The pattern and mask must be specified in the same format as specified in the

SATA Standard.
Sierra M6‐2 SAS/SATA Protocol Analyzer User Manual
Scenario Events