Teledyne Sierra M6-2 User Manual page 394

Teledyne LeCroy
392
Action
Branch to Existing State
1
New State
Capture Data DWORD
Inject CRC Error
Invalid 10bit‐code
Error
Running Disparity
Error
Insert Address Frame
FIS Frame
SAS Primitive
SMP Frame
SSP Frame
Insert DWORD
Internal Trigger
Link Disconnect
Reconnect
Marker
Monitor/Count
Remove Frame Partially
Primitive
Whole Frame
Restart
All Sequences
Current Sequence
Description
1 Go to a state in this sequence that is already
1
defined.
Go to a state in this sequence that is not yet defined
(you need to define it).
Captures a data DWORD into one of four registers.
Injects a CRC error into the line.
Injects invalid 10b code into the line.
Injects a Running Disparity (RD) error into traffic.
Inserts a frame or primitive.
Inserts DWORD.
Allows user to send a trigger (notification) to other
ports. See "Generating an Internal Trigger" on
page 397.
Puts both InFusion SAS ports at electrical idle
immediately. This action is only in effect while the
scenario is running, and the Jammer will reconnect
the line when the scenario is stopped.
Starts traffic pass‐through immediately. This action
restarts traffic after a previous disconnect command.
Once traffic is passing through, the initiator and
target resume OOB signaling.
The main purpose of this feature is enabling the user
to mark specific parts of the captured traffic for
better tracking. See
on page 398.
Opens a window to count the number of events that
occur during a session. A session is a time interval
during which a scenario runs.
Removes the targeted event from the traffic.
1
Restart all sequences in the scenario.
Restart the sequence that contains this action
1
1
definition.
Sierra M6‐2 SAS/SATA Protocol Analyzer User Manual
Scenario Actions
1
"Generating a Jammer Marker"
1